Balsa Wood Super Cub Build: Part 3

Hi guys,

So we now have a set of wings ( https://motorsportformentalhealth.com/2017/02/20/balsa-wood-super-cub-build-part-2/ ) and a rudder, stabiliser and a set of wing mounts ( https://motorsportformentalhealth.com/2017/01/30/balsa-wood-super-cub-build-part-1/ )

Today I present to you duh duh daah the fuselage!

DSC_0056

Now, yes I have to admit that I am a terrible blogger and just sort of cracked into this without stopping to take photos as I went along. The premise is similar to the wings though. The sides are made out of several die cut pieces as are the fuselage and lengths of balsa strip cut to length complete the structure.

The landing gear is basically a bit of aluminium bent to shape. It is provided with the kit but it’s great that it’s another part that can be easily replicated if it is damaged in an accident.

DSC_0058

Of course, I couldn’t just have all the components there without taping them together could I? It’s starting to look like a proper little aeroplane now!

DSC_0059DSC_0060

Now, the rubber band motor is ran down the length of the aeroplane and then has a rubber dowel put through the rear end to hold it in place and a hook on the end of the propeller which you turn to wind the band up. The instructions say to put the band in after the aircraft has been skinned but it gets caught up on the bulkheads and once the aircraft is skinned you can’t manually guide it right down the back of the aircraft. So I’m putting the band in first.

The band itself is just a long bit of elastic which you have to tie a knot in like so:

DSC_0061

This is then fed down the nose of the aircraft to the tail where it is held in by a wooden dowl that is pushed through the side of the aircraft (the sticky out bits)

DSC_0062

Now all there is to do is trim the dowel to the correct length and file it to be flush with the fuselage.

DSC_0063

There we have it! One fuselage built and one motor installed! Next time we should be putting the skin over the frame!

Thanks for reading if you would like to see more of these posts make sure to follow this blog or follow me on the following social media platforms

Facebook: https://www.facebook.com/RFrancisGarageR/
Twitter: @Garage_RFrancis
Instagram: @motorsport4mentalhealth
Youtube: https://www.youtube.com/channel/UCNBY-2P5EuEFotY4RVjpvnw

Advertisements

2 Comments

  1. It’s quite easy to feed the rubber band down through the the finished model ,using a length of wire coat hanger ,
    Also the peg that holds the rubber in place should protrude on both sides ,so you can remove it ,to replace the rubber band if it snaps.

    Like

    1. It protrudes by about 1mm so it can be removed and fed back into the model of needs be 🙂 seeing as it’s my first balsa build though I doubt it will survive long enough for the band to start deteriorating haha!

      Like

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s